Field Report: Behringer EPA150

August 1, 2011


When choosing a PA system, the main factor to take in is how much area needs to be covered with sound. The most looked at aspect is having a system that is big enough. You don't want to under-do it, but at the same time, you can easily over-do it. This is most obvious when the poor remote engineer is lugging PA equipment that requires several trips and a dolly to haul the super-sized speakers into a small room. I have seen and set up remotes that once all the broadcast cases and PA equipment were set up there was no room for the talent in the broadcast area. So I have found a PA that not only takes up little space, but also can provide enough sound to cover the smaller areas (e.g. strip mall stores) and save the engineer's back.

Behringer EPA 150

The Behringer EPA150 is a convenient 75W-per-output channel PA that fits into a case the size of a medium suitcase (13.8" x 24.1" x 7.3"). This portable unit contains two speakers, a mixing board, a zipper case for storing the included microphone, speaker cables and power cord. The case opens to pop out the speakers and then can be propped open to provide protected access to the mixer. The entire unit sets up in seconds. All sections on the mixer are well labeled so that set up is nearly obvious.

Added features

The mixer is unique in that it contains a studio-grade 24-bit effects processor with 100 presets including reverb, chorus, flanger, delay, pitch shifter and various multi-effects. This may not be a requirement for a remote broadcast PA, but this demonstrates the versatility of this system. Musicians would love this portable system for playing the local bar or coffee house and so will radio engineering professionals for filling a remote broadcast with sonic performance.

The mixer also contains the FBQ Feedback Detection system that instantly reveals frequencies for feedback removal. While this is not going to remove all feedback, it will remove those accidental occurrences on most occasions. This is great when using the PA for interviews or when the talent wanders too close to the speakers.

Performance at a glance
Portable, small size
Fast, easy setup
24-bit effects processor
Feedback detection system
Five inputs, four outputs

The microphone included is the Behringer XM1800s and also comes with a mic clip and cable. This is a nice mic with a two-stage pop-filter, presence lift in the mid-range, cardioid pattern with feedback suppression (added plus with the FBQ system built-in to mixer), and balanced XLR output.

Before I go into specifics about the inputs and outputs of this system I would like to point out that this also features the Planet Earth switching power supply for flexibility (100 - 240Vac). Providing noise-free audio, and low power consumption for energy savings (or maybe having to pull off a generator, this will not bog down the generator.)

As for the inputs, this mixer has five inputs including two "invisible" mic pre-amps with phantom power for condenser mics, one microphone/instrument channel and one stereo channel with separate CD input (via RCA jacks). Channels one and two are the mic inputs with XLR and 1/4" jack inputs; channel three is the microphone/instrument channel providing two 1/4" jacks one for microphone or instrument and the other for line-in. Channels four and five are the stereo inputs with 1/4" jack inputs or RCA inputs.

- continued on page 2



The closed case

The closed case


Looking at the outputs there are four usable outputs: a 1/4" jack main output for the speakers, an RCA stereo output, a direct mono out 1/4" jack and a stereo headphone 1/4" jack.

On the mixer itself there are six sliders controlling the inputs and outputs. From left to right, channels one through three each contain pots for bass, mid range, and treble controls and an effects pot for adjusting the level of effects desired. Channels four and five are the stereo channels and ganged together in one slider and contain the same pots as one through three. The last two sliders are for the main level output control. There is also a pot for headphone volume. Across the top of the mixer is an equalizer with the FBQ feedback detection. This is operated with the typical sliders of an equalizer with seven bands for frequency controls. The EQ and FBQ each have a button for turning them off and on. Then an LED readout appears for selecting the effects.

Housed within the speakers are a 4" woofer and a 1" tweeter. The speakers also have a 17mm stand insert for use with standard microphone stands and 12' cables.

Behringer
P
W
E
425-672-0816
www.behringer.com
support@behringer.de

This system is perfect for use when you need just enough sound and fast setup. The EPA 150 also has versatility in providing the perfect PA for a small band and I even used the system to provide a PA and mixing board for a production studio with just my laptop and the Behringer USB adapter (not included).


Wilson is an announcer, producer, webmaster and promotions guy at WAKO-AM/FM, Lawrenceville, IL.

Editor's note: Field Reports are an exclusive Radio magazine feature for radio broadcasters. Each report is prepared by well-qualified staff at a radio station, production facility or consulting company.

These reports are performed by the industry, for the industry. Manufacturer support is limited to providing loan equipment and to aiding the author if requested.

It is the responsibility of
Radio magazine to publish the results of any device tested, positive or negative. No report should be considered an endorsement or disapproval by Radio magazine.



Comments